Instructions for Authors of SBC Conferences
Papers and Abstracts
Luciana P. Nedel1 , Rafael H. Bordini2 , Flávio Rech Wagner1 , Jomi F. Hübner3
1
Instituto de Informática – Universidade Federal do Rio Grande do Sul (UFRGS)
Caixa Postal 15.064 – 91.501-970 – Porto Alegre – RS – Brazil
2
Department of Computer Science – University of Durham
Durham, U.K.
3
Departamento de Sistemas e Computação
Universidade Regional de Blumenal (FURB) – Blumenau, SC – Brazil
{nedel,flavio}@inf.ufrgs.br, [email protected], [email protected]
Abstract. This meta-paper describes the style to be used in articles and short
papers for SBC conferences. For papers in English, you should add just an
abstract while for the papers in Portuguese, we also ask for an abstract in Portuguese (“resumo”). In both cases, abstracts should not have more than 10 lines
and must be in the first page of the paper.
Resumo. Este meta-artigo descreve o estilo a ser usado na confecção de artigos
e resumos de artigos para publicação nos anais das conferências organizadas
pela SBC. É solicitada a escrita de resumo e abstract apenas para os artigos
escritos em português. Artigos em inglês deverão apresentar apenas abstract.
Nos dois casos, o autor deve tomar cuidado para que o resumo (e o abstract)
não ultrapassem 10 linhas cada, sendo que ambos devem estar na primeira
página do artigo.
1. General Information
All full papers and posters (short papers) submitted to some SBC conference, including
any supporting documents, should be written in English or in Portuguese. The format
paper should be A4 with single column, 3.5 cm for upper margin, 2.5 cm for bottom
margin and 3.0 cm for lateral margins, without headers or footers. The main font must
be Times, 12 point nominal size, with 6 points of space before each paragraph. Page
numbers must be suppressed.
Full papers must respect the page limits defined by the conference. Conferences
that publish just abstracts ask for one-page texts.
2. First Page
The first page must display the paper title, the name and address of the authors, the abstract
in English and “resumo” in Portuguese (“resumos” are required only for papers written
in Portuguese). The title must be centered over the whole page, in 16 point boldface font
and with 12 points of space before itself. Author names must be centered in 12 point font,
bold, all of them disposed in the same line, separated by commas and with 12 points of
space after the title. Addresses must be centered in 12 point font, also with 12 points of
space after the authors’ names. E-mail addresses should be written using font Courier
New, 10 point nominal size, with 6 points of space before and 6 points of space after.
The abstract and “resumo” (if is the case) must be in 12 point Times font, indented
0.8cm on both sides. The word Abstract and Resumo, should be written in boldface and
must precede the text.
3. CD-ROMs and Printed Proceedings
In some conferences, the papers are published on CD-ROM while only the abstract is
published in the printed Proceedings. In this case, authors are invited to prepare two final
versions of the paper. One, complete, to be published on the CD and the other, containing
only the first page, with abstract and “resumo” (for papers in Portuguese).
4. Sections and Paragraphs
Section titles must be in boldface, 13pt, flush left. There should be an extra 12 pt of space
before each title. Section numbering is optional. The first paragraph of each section
should not be indented, while the first lines of subsequent paragraphs should be indented
by 1.27 cm.
4.1. Subsections
The subsection titles must be in boldface, 12pt, flush left.
5. Figures and Captions
Figure and table captions should be centered if less than one line (Figure 1), otherwise
justified and indented by 0.8cm on both margins, as shown in Figure 2. The caption font
must be Helvetica, 10 point, boldface, with 6 points of space before and after each caption.
Figure 1. A typical figure
In tables, try to avoid the use of colored or shaded backgrounds, and avoid thick,
doubled, or unnecessary framing lines. When reporting empirical data, do not use more
Figure 2. This figure is an example of a figure caption taking more than one line
and justified considering margins mentioned in Section 5.
decimal digits than warranted by their precision and reproducibility. Table caption must
be placed before the table (see Table 1) and the font used must also be Helvetica, 10 point,
boldface, with 6 points of space before and after each caption.
Table 1. Variables to be considered on the evaluation of interaction techniques
6. Images
All images and illustrations should be in black-and-white, or gray tones, excepting for
the papers that will be electronically available (on CD-ROMs, internet, etc.). The image
resolution on paper should be about 600 dpi for black-and-white images, and 150-300 dpi
for grayscale images. Do not include images with excessive resolution, as they may take
hours to print, without any visible difference in the result.
7. References
Bibliographic references must be unambiguous and uniform. We recommend giving the
author names references in brackets, e.g. [Knuth 1984], [Boulic and Renault 1991], and
[Smith and Jones 1999].
The references must be listed using 12 point font size, with 6 points of space
before each reference. The first line of each reference should not be indented, while the
subsequent should be indented by 0.5 cm.
References
Boulic, R. and Renault, O. (1991). 3d hierarchies for animation. In Magnenat-Thalmann,
N. and Thalmann, D., editors, New Trends in Animation and Visualization. John Wiley
& Sons ltd.
Knuth, D. E. (1984). The TEX Book. Addison-Wesley, 15th edition.
Smith, A. and Jones, B. (1999). On the complexity of computing. In Smith-Jones, A. B.,
editor, Advances in Computer Science, pages 555–566. Publishing Press.